Fig. 1. Schematic illustration of SLM-based parallel micro/nano lithography system^[12]

Fig. 2. Principle and experimental results of multi-focus array produced by parallel micro/nano lithography. (a) Schematic diagram of multifocal modulation lithography system with spatial light modulator combined with micro-lens or zone plate array; (b) microstructure with characteristic size of 1.5 μm fabricated by multifocal parallel lithography^[14]; (c) complex geometry and photonic devices fabricated by lithography^[15]; (d) schematic diagram of holographic multifocal modulation lithography based on spatial light modulator; (e) schematic diagram of spiral photonic structure for parallel manufacturing of multifocal array, 45 focus fabricated “L” structure, 60 focus fabricated “Z” structure^[18]

Fig. 3. Optimized processing by multifocal parallel micro/nano lithography. (a) Single focus,3 foci, 6 foci parallel manufacturing of sine curve structure diagram^[26]; (b) formation of a 4×4 micrograph within 45 seconds^[27]; (c) fabrication of same tissue scaffold structure using single beam and multiple beams^[27]

Fig. 4. Principle of SLM-based direct projection micro-stereoscopic lithography^[42]

Fig. 5. Microstructure formed by direct projection parallel lithography based on spatial light modulator. (a) Extracellular microenvironment was constructed, and four kinds of micro-pores were made on a single chip^[54]; (b) stepwise; (c) spiral; (d) embryo-like; (e) flower-like; (f) micro-fans structure with 50 layers high and 10 μm thick; (g) micro-wineglass with 300 layers high and 4 μm thick^[55]; (h) single micro-gear structure fabricated on hydrogel^[58]

Fig. 6. Letters, triangle, and circles formed by linear holographic projection light field micro/nano lithography^[59]

Fig. 7. Microstructure fabricated by modulating the incident light field into a “T” shaped light field, and the light source power is 560 mW. (a) 5 s; (b) 1 s; (c) 0.5 s; (d) 0.2 s^[59]

Fig. 8. Incident light field is modulated into a uniform annular light field with controllable diameter, and the diameter is 25 μm tubular structure array, fabrication time is 15 s^[60]

Fig. 9. Light field is modulated into circular, square, and triangular microstructure lithography results^[59]. (a)‒(c) Lithography results before optimization; (d)‒(f) optimized lithography results

Fig. 10. Intensity distribution diagram when the beam is shaped into different patterns and the corresponding figure on DMD^[64]. (a) Airy beam intensity distribution; (b) Bessel beam intensity distribution; (c) DMD display of the airy beam; (d) DMD display of the Bessel beam

Fig. 11. Cylindrical microstructure formed by Bessel beam lithography with different parameters^[65]. (a) Hologram generating Bessel beam; (b) lithography results of cylindrical microstructure with different diameters