[1] [1] Yu Ping’an, Zhu Ruian, Yu Zhenwan, et al. Thermal analysis of nuclear reacts[M]. Shanghai: Shanghai Jiaotong University Press, 2002

[2] Åbro E, Johansen G A. Improved void fraction determination by means of multibeam gamma-ray attenuation measurements[J]. Flow Measurement and Instrumentation, 10, 99-108(1999).

[3] Rahim R A, Rahiman M H F, Chan K S et al. Non-invasive imaging of liquid/gas flow using ultrasonic transmission-mode tomography[J]. Sensors and Actuators A: Physical, 135, 337-345(2007).

[4] Yun B J, Park G C, Julia J E et al. Flow structure of subcooled boiling water flow in a subchannel of 3×3 rod bundles[J]. Journal of Nuclear Science and Technology, 45, 402-422(2008).

[5] Hosokawa S, Hayashi K, Tomiyama A. Void distribution and bubble motion in bubbly flows in a 4×4 rod bundle. Part I: experiments[J]. Journal of Nuclear Science and Technology, 51, 220-230(2014).

[6] Ren Quanyao, Pan Liangming, Zhou Wenxiong et al. Phase distribution characteristics of bubbly flow in 5×5 vertical rod bundles with mixing vane spacer grids[J]. Experimental Thermal and Fluid Science, 96, 451-459(2018).

[7] Yang X, Schlegel J P, Liu Y et al. Experimental study of interfacial area transport in air–water two phase flow in a scaled 8×8 BWR rod bundle[J]. International Journal of Multiphase Flow, 50, 16-32(2013).

[8] Shen Xiuzhong, Miwa S, Xiao Yigeng et al. Local measurements of upward air-water two-phase flows in a vertical 6×6 rod bundle[J]. Experimental and Computational Multiphase Flow, 1, 186-200(2019).

[9] Han Xu, Shen Xiuzhong, Yamamoto T et al. Experimental study on local interfacial parameters in upward air-water bubbly flow in a vertical 6×6 rod bundle[J]. International Journal of Heat and Mass Transfer, 144, 118696(2019).

[10] Prasser H M, Böttger A, Zschau J. A new electrode-mesh tomograph for gas–liquid flows[J]. Flow Measurement and Instrumentation, 9, 111-119(1998).

[11] [11] Ylönen A T. Highresolution flow structure measurements in a rod bundle[D]. Lappeenranta: Lappeenranta University of Technology, 2013.

[12] Xiong Jinbiao, Xie Hao, Du Sijia et al. Experimental measurement of bubbly two-phase flow in a 4x4 rod bundle with wire mesh sensor[J]. Applied Thermal Engineering, 218, 119294(2023).

[13] Wang Yinglong, Xie Hao, Xiong Jinbiao. Research on void distribution measurement of 5×5 rod bundle channel based on wire mesh sensor[J]. Nuclear Power Engineering, 43, 84-91(2022).

[14] Tomiyama A, Tamai H, Zun I et al. Transverse migration of single bubbles in simple shear flows[J]. Chemical Engineering Science, 57, 1849-1858(2002).

[15] Zhang Hengwei, Xiao Yao, Gu Hanyang. Experimental investigation of two-phase flow evolution in a tight lattice bundle using wire-mesh sensor[J]. International Journal of Heat and Mass Transfer, 171, 121079(2021).

[16] Yan Xu, Xiao Yao, Zhang Hengwei et al. Experimental investigation of gas-phase migration behaviors in a tight lattice bundle under two-phase non-equilibrium flow[J]. Chemical Engineering Science, 282, 119315(2023).

[17] Prasser H M. Evolution of interfacial area concentration in a vertical air–water flow measured by wire–mesh sensors[J]. Nuclear Engineering and Design, 237, 1608-1617(2007).

[18] Zuber N, Findlay J A. Average volumetric concentration in two-phase flow systems[J]. Journal of Heat Transfer, 87, 453-468(1965).

[19] Bestion D. The physical closure laws in the CATHARE code[J]. Nuclear Engineering and Design, 124, 229-245(1990).

[20] Ozaki T, Suzuki R, Mashiko H et al. Development of drift-flux model based on 8×8 BWR rod bundle geometry experiments under prototypic temperature and pressure conditions[J]. Journal of Nuclear Science and Technology, 50, 563-580(2013).

[21] Han Xu, Shen Xiuzhong, Yamamoto T et al. Flow regime and void fraction predictions in vertical rod bundle flow channels[J]. International Journal of Heat and Mass Transfer, 178, 121637(2021).