[2] [2] WANG X T, DUAN J Z, ZHANG J, et al. Alloy elements' effect on anti-corrosion performance of low alloy steels in different sea zones[J]. Mater Lett, 2008, 62(8/9): 1291–1293.

[4] [4] SERDAR M, MERAL C, KUNZ M, et al. Spatial distribution of crystalline corrosion products formed during corrosion of stainless steel in concrete[J]. Cem Concr Res, 2015, 71: 93–105.

[5] [5] SINGH A K, RANI N, KUNDU S. Optimized Cr concentration in reinforcement steel for high corrosion resistance in simulated pore solution by electrochemical and cyclic corrosion tests[J]. ISIJ Int, 2016, 56(8): 1470–1479.

[10] [10] ABD EL HALEEM S M, ABD EL AAL E E, ABD EL WANEES S, et al. Environmental factors affecting the corrosion behaviour of reinforcing steel: I. The early stage of passive film formation in Ca(OH)2 solutions[J]. Corros Sci, 2010, 52(12): 3875–3882.

[14] [14] YANG L T, CHIANG K T, YU H, et al. Threshold chloride levels for localized carbon steel corrosion in simulated concrete pore solutions using coupled multielectrode array sensors[J]. Corrosion, 2014, 70(8): 850–857.

[15] [15] ZHENG H B, DAI J G, POON C S, et al. Influence of calcium ion in concrete pore solution on the passivation of galvanized steel bars[J]. Cem Concr Res, 2018, 108: 46–58.

[16] [16] KITOWSKI C J, WHEAT H G. Effect of chlorides on reinforcing steel exposed to simulated concrete solutions[J]. Corrosion, 1997, 53(3): 216–226.

[17] [17] ROSAS O, MAYA-VISUET E, CASTANEDA H. Effect of chloride ions on the electrochemical performance of LDX 2003 alloy in concrete and simulated concrete-pore solutions[J]. J Appl Electrochem, 2014, 44(5): 631–646.

[18] [18] LIU R, JIANG L H, XU J X, et al. Influence of carbonation on chloride-induced reinforcement corrosion in simulated concrete pore solutions[J]. Constr Build Mater, 2014, 56: 16–20.

[19] [19] ZHANG Y, POURSAEE A. Passivation and corrosion behavior of carbon steel in simulated concrete pore solution under tensile and compressive stresses[J]. J Mater Civ Eng, 2015, 27(8): 0001199.

[20] [20] KULAKOWSKI M P, PEREIRA F M, MOLIN D C C D. Carbonation-induced reinforcement corrosion in silica fume concrete[J]. Constr Build Mater, 2009, 23(3): 1189–1195.

[21] [21] SUN W, ZHANG Y S, LIU S F, et al. The influence of mineral admixtures on resistance to corrosion of steel bars in green high-performance concrete[J]. Cem Concr Res, 2004, 34(10): 1781–1785.

[22] [22] TOPU B, BOA A R. Effect of ground granulate blast-furnace slag on corrosion performance of steel embedded in concrete[J]. Mater Des, 2010, 31(7): 3358–3365.

[23] [23] ZHANG J, YANG J, YING Z X. Study on mechanical properties of metakaolin-based concretes and corrosion of carbon steel reinforcement in 3.5% NaCl[J]. Int J Electrochem Sci, 2020, 15(4): 2883–2893.

[25] [25] LI Z N, SHEN A Q, YANG X R, et al. A review of steel slag as a substitute for natural aggregate applied to cement concrete[J]. Road Mater Pavement Des, 2023, 24(2): 537–559.

[26] [26] PENG Y J, LIU Z, LIU X, et al. Preparation of composite micro-slag based on the application of tailings slag in cement and concrete[J]. Constr Build Mater, 2022, 322: 126515.

[28] [28] SONG G L. Theoretical analysis of the measurement of polarisation resistance in reinforced concrete[J]. Cem Concr Compos, 2000, 22(6): 407–415.

[29] [29] LIU G J, ZHANG Y S, WU M, et al. Study of depassivation of carbon steel in simulated concrete pore solution using different equivalent circuits[J]. Constr Build Mater, 2017, 157: 357–362.

[30] [30] SHI J J, SUN W, JIANG J Y, et al. Influence of chloride concentration and pre-passivation on the pitting corrosion resistance of low-alloy reinforcing steel in simulated concrete pore solution[J]. Constr Build Mater, 2016, 111: 805–813.

[31] [31] ZHOU X, LIAO C H, WANG Y F, et al. Constructing the Pourbaix diagram of Fe–Cl–H2O ternary system under supercritical water conditions[J]. Electrochim Acta, 2021, 377: 138075.

[32] [32] MUOZ-PORTERO M J, NACHIONDO T, BLASCO-TAMARIT E, et al. Potential-pH diagrams of iron in concentrated aqueous LiBr solutions at 25 ℃[J]. Corrosion, 2018, 74(10): 1102–1116