[4] [4] FAYYAZ A, MUHAMAD N, SULONG A B, et al. Micro-powder injection molding of cemented tungsten carbide: feedstock preparation and properties［J］. Ceramics International, 2015, 41(3): 3605-3612.

[6] [6] WEN J X, XIE Z P, CAO W B, et al. Effects of different backbone binders on the characteristics of zirconia parts using wax-based binder system via ceramic injection molding［J］. Journal of Advanced Ceramics, 2016, 5(4): 321-328.

[7] [7] YANG S D, ZHANG R J, QU X H. X-ray analysis of powder-binder separation during SiC injection process in L-shaped mould［J］. Journal of the European Ceramic Society, 2015, 35(1): 61-67.

[8] [8] LIU D M, TSENG W J. Influence of debinding rate, solid loading and binder formulation on the green microstructure and sintering behaviour of ceramic injection mouldings［J］. Ceramics International, 1998, 24(6): 471-481.

[11] [11] YANG X F, YANG J H, XU X W, et al. Injection molding of ultra-fine Si3N4 powder for gas-pressure sintering［J］. International Journal of Minerals, Metallurgy, and Materials, 2015, 22(6): 654-659.

[13] [13] HANEMANN T. Influence of particle properties on the viscosity of polymer-alumina composites［J］. Ceramics International, 2008, 34(8): 2099-2105.

[14] [14] LII D F, HUANG J L, LIN C H, et al. The effects of atmosphere on the thermal debinding of injection moulded Si3N4 components［J］. Ceramics International, 1998, 24(2): 99-104.

[15] [15] HRDINA K E, HALLORAN J W, OLIVEIRA A, et al. Chemistry of removal of ethylene vinyl acetate binders［J］. Journal of Materials Science, 1998, 33(11): 2795-2803.