Bulletin of the Chinese Ceramic Society, Volume. 42, Issue 2, 719(2023)
Photosensitive Resin System for Photocuring 3D Printing Ceramic Components
The photosensitive resin system affects the shrinkage rate in the molding process of the photocurable 3D printing ceramic components and the stress in the degreasing process. In this paper, three resin systems, including the monofunctional resin with ring structure, the trifunctional resin and the multi-component resin with the introduction of prepolymer and diluent, were designed. The shrinkage rate of the three resin systems was tested. The research shows that the resin system with the introduction of prepolymer and diluent has the lowest curing shrinkage rate, which effectively alleviates the problem of cracking of 3D printed alumina ceramic blank caused by curing reaction shrinkage. The thermal decomposition behavior of three resin systems was studied by thermogravimetric analysis and heat treatment experiments. The multi-component resin system has the characteristics of staged pyrolysis. The photosensitive aluminum oxide slurry was prepared by using this resin system, and the photocuring printing parameters and degreasing atmosphere were optimized. The 3D printing thick wall solid (12 mm×12 mm×12 mm) samples and large sizes (80 mm×50 mm) aluminum oxide ceramic green body are both degreased without cracks.
Get Citation
Copy Citation Text
LI Shan, ZHANG Yubei, LIU Bingshan, WANG Gong, DUAN Wenyan, HU Chuanqi, LI Yuan. Photosensitive Resin System for Photocuring 3D Printing Ceramic Components[J]. Bulletin of the Chinese Ceramic Society, 2023, 42(2): 719
Category:
Received: Sep. 17, 2022
Accepted: --
Published Online: Mar. 17, 2023
The Author Email: Shan LI (lishan@csu.ac.cn)
CSTR:32186.14.